Epoxy and Concrete Coating Supplies in Murrieta, CA

The new Murrieta store opens this August. The exact day gets announced soon, so check back or call. Doors open at 7:00 AM.

41655 Reagan Way, Suite B, Murrieta, CA 92562. Hit the directions button in the location section and it will route you straight to the counter.

7:00 AM to 4:00 PM to start, so you can load material before you need to be on the job site. Weekend hours: call to confirm. Call the store and we will tell you what is in stock before you drive over.

Contractors only. We are a supply house for the trade. If you are a homeowner planning a floor, send your installer in for the material.

No account needed. Counter sales are contractors only. If you buy in volume, ask at the counter about repeat account pricing.

That is the point of the store. Most products are on the shelf. Call ahead, we pull and stage your order, you load and go. Will call and truck loading available.

Yes. Local runs go out by truck and longer hauls ship by freight, depending on the distance. Call the counter with your job address for cost and timing. For nearby jobs, same-day pickup is still fastest.

Grind to open the slab, patch spalls, then prime. A moisture-tolerant primer under 100 percent solids epoxy with a full chip broadcast and a polyaspartic topcoat is the standard garage system. Bring your slab details to the counter and we will spec the kit.

Tape a 2 foot square of plastic sheeting to the slab and check it after 24 hours. Condensation or darkened concrete means vapor is moving. For hard numbers, run a calcium chloride test or a relative humidity probe. If the slab reads hot, start with a moisture vapor barrier primer.

Epoxy builds thickness, wets into the concrete, and costs less per mil. Polyaspartic cures fast, holds color in UV, and gets the floor back in service the next morning. Most garage systems run both: epoxy base coat, polyaspartic topcoat. Watch your pot life on polyaspartic and mix small.

Coverage depends on mils and porosity. A 3 gallon kit of 100 percent solids epoxy runs about 450 square feet at 10 mils on a tight slab. Ground or porous concrete drinks more. Tell the counter your square footage and we will size the kits so you do not come up short.